[BUGS] X windows Woes
Jerahmy Pocott
quakenet1 at optusnet.com.au
Sat Mar 15 10:36:45 EST 2008
On 14/03/2008, at 5:08 PM, Glenn Mawby wrote:
> Section "Monitor"
> Identifier "Monitor0"
> #DisplaySize 411 263
> ModeLine "1440x900" 136.75 1440 1536 1688 1936 900 903 909
> 942 -hsync +vsync
> #ModeLine "1440x900_106.6" 106.50 1440 1520 1672 1904 900
> 903 909 934 +hsync -vsync
> #HorizSync 28.0 - 83.0
> #VertRefresh 56.0 - 75.0
>
> Option "DPMS"
> EndSection
From your log:
(--) NV(0): Virtual size is 1440x900 (pitch 1440)
(**) NV(0): *Driver mode "1440x900": 106.5 MHz, 55.9 kHz, 59.9 Hz
(II) NV(0): Modeline "1440x900" 106.50 1440 1520 1672 1904 900 903
909 934 +hsync -vsync
(**) NV(0): Driver mode "1440x900": 136.8 MHz, 70.6 kHz, 75.0 Hz
(II) NV(0): Modeline "1440x900" 136.75 1440 1536 1688 1936 900 903
909 942 -hsync +vsync
(**) NV(0): Mode "1440x900": 136.8 MHz, 70.6 kHz, 75.0 Hz
(II) NV(0): Modeline "1440x900" 136.75 1440 1536 1688 1936 900 903
909 942 -hsync +vsync
As you can see the first detected mode for 1440x900 is giving you the
106.5 value and you never specified in your configuration which
1440x900 mode to use, even though you put the one you wanted into the
monitor section, they are ALL called "1440x900".. You can see the mode
you specified in the config file is showing up twice (once by auto
detect and once by being listed on the mode line), but the
identification string is the same for all three.
Change it to the following:
ModeLine "1440x900_136_75" 136.75 1440 1536 1688 1936 900 903 909 942 -
hsync +vsync
Option "Preferred Mode" "1440x900_136_75"
That then uniquely identifies that mode, the part in "" can be
anything you want, it's just a string to identify the mode..
Good luck!
Jerahmy.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://mailman.barnet.com.au/pipermail/bugs/attachments/20080315/305da7b4/attachment.html
More information about the BUGS
mailing list